Unisteer Power Small Block Chevy Camaro Nova Rack & Pinion + Steering Shaft Kit
Unisteer Power Small Block Chevy Camaro Nova Rack & Pinion + Steering Shaft Kit. This listing is for a Brand New Unisteer Power Rack and Pinion and Steering Shaft Kit designed to be used on 1967 1968 1969 Camaro and 1968 1969 1970 1971 1972 1973 1974 Novas with a Small Block Chevy Engine. He Rack & Pinion that comes with this kit, is a highly modified GM rack & pinion: it has been internally shortened, reducing the width of the ball centers.By narrowing these pivot points, the rack & pinion pivots in the same position as the upper and lower control arms of stock Camaro, replicating the dimensions of the stock steering and resulting in precision rack & pinion steering with very little bump steer! Better yet, the installation of the 67-69 Camaro, 68-74 Nova Rack & Pinion kit is a breeze!
This is a bolt on kit, no welding or chassis modification required. The rack & pinion comes mounted to its own unique bracket that mounts to the bottom two control arm bolts on the rear of the cross member. To install, simply remove the existing bolts and replace with the provided longer bolts, bolting the rack up into position. Then unbolt the stock steering arms and replace them with new steering arms provided, and attached the provided outer tie-rod ends, that is all that the kit consists off. Everything is included, the uniquely modified power rack & pinion, attached to the bolt on bracket, mounting hardware, new steering arms and outer tie-rod ends, banjo fittings for the rack, and installation instruction sheet.This kit is designed for small block engines. As for steering linkage; there is enough room to run a section of shaft and two u-joints, or if necessary, three u-joints with a support bearing, depending on the headers. In regards to the pump, the factory power steering pump on the Camaro will work but will require new lines. If you do not have a pump, we recommend using a pump that was intended for use on a car with a rack & pinion, thus avoiding super sensitive steering.
This kind of pump should be a low flow and low pressure pump. The 67'-69' Power Camaro Rack & Pinion kit is recommended for street use.
- Manufacturer Part Number: 8010540-01 + 8050490
- Brand: Gearhead