Mustang II 2 Power Rack & Pinion Steering + Pump Hoses Shaft Kit Tie Rod Bolts +
Mustang II 2 Power Rack & Pinion Steering + Pump Hoses Shaft Kit Tie Rod Bolts +. This is a Mustang II Power Steering rack and pinion unit. This is for the 74-78 style Mustang II front suspensions, which is one of the most common front ends found on Street Rods today. The Power Rack has a 15 1/2 Center to Center Mounting Pattern, which fits most aftermarket Mustang II crossmembers. Make sure to check this, as most.
Mustang II crossmembers are 16 center to center. Check our other listings for a kit with offset bushings if you need it to fit 16 mounting holes. These are very nice quality racks and are one of the least expensive ways to upgrade the steering on your Mustang II front suspension. A pair of outer tie rod ends (includes cotter pins and castle nuts).
Correct 3/4 - 36 spline stainless U-joint other end of the joint connects to a standard 3/4 DD shaft. 3 foot 3/4 DD steering shaft. Stainless U-joint to connect from the steering shaft to a 1 DD steering column. Chrome GM Saginaw Style power steering pump.Chrome Steel Power Steering Pump Pulley (single groove). Correct Braided stainless hose kit to connect the Mustang rack to the GM Pump. Steel power steering pump mounting bracket for Big Block Chevy engine with a Short Water Pump. This kit is a very complete install, very little should be needed to complete the power steering upgrade on your street rod with this kit. # Must II Power Rack (313B) + 1pr Tie Rod Ends + 1pr Bushings + 1pr Pwr Rack Bolts + UJSS003 + UJSS004 + 3ft Plain DD.
- Manufacturer Part Number: Must II Power Rack + 1pr) Tie Rod Ends + 1pr
- Brand: Gearhead Enterprises